High Frequency Induction Heating Equipment Forging Heat Treatment
Equipment For Small High-Frequency Quenching Machine
Overview of high-frequency induction heating products:
The high-frequency heater can be used to assemble or disassemble
the inner sleeve, bearing inner ring, coupling, gear, etc. of
cylindrical roller bearing, so that the efficiency of induction
heating is higher. The ordinary power frequency heater has no way
to disassemble small workpieces. At this time, the disassembler
with medium cycle heating is used. The medium cycle induction
heater has the advantages of high thermal efficiency, fast heating
speed, etc.
Technical parameters of high frequency induction heating equipment:
Model: LC-GPGY-145KW
Maximum input current: 145A
Input power: 145kW
Oscillation frequency: 33khz
Input voltage: 380v
Host volume: 480mm×380mm×680mm
Cooling water pressure: 0.1-0.3mpa
Cooling water flow (main engine): 15L / min (0.1MPa)
Cooling water flow (transformer): 18L / min (0.1MPa)
Water temperature protection point: 50 ℃
Host weight: 40 ± 5% kg
Efficiency: 90%
Advantages of high-frequency induction heating equipment:
1. Fast heating, the fastest heating speed is less than 1s (the
speed can be adjusted and controlled);
2. It is easy to install and connect the power supply, induction
coil and water inlet and outlet pipes for use; Small size, light
weight, easy to use;
3. Wide range of heating can be used to heat various metal
workpieces (removable induction coils can be replaced according to
different working switches);
4. When the power is controllable, the power can be adjusted to
meet the needs of different heating temperatures and speeds
5. Less power consumption is about 70% less than that of the old
electronic tube high-frequency equipment. The smaller the
workpiece, the less power consumption;
6. The heating can be started after the quick opening water is
powered on
7. It can be learned after a few minutes of simple operation;
8. The protection is fully equipped with alarm indications of
overvoltage, overcurrent, overheating, water shortage, etc., and is
automatically controlled and protected
9. Good effect, very uniform heating, fast temperature rise, less
oxide layer, no waste after annealing;
