Industrial Intelligent Electric Boiler 700KW Intelligent
Temperature Control Heating
Description Of Electric Heater Boiler Heating:
The electric heater boiler uses the electromagnetic induction
principle to heat 1L water, and the power consumption is 0.117
degrees. Use an electric heating tube to heat 1L of water, and the
power consumption is 0.289 degrees. Compared with the two phases,
the electromagnetic induction principle is adopted for heating, and
the power saving is about 2.5 times.
Product features: energy saving, environmental protection, low
carbon, intelligent, safe and durable.
Electric Heater Boiler Technical Parameter:
| Serial number | Product model | Company | LC-L-700kw |
| 1 | Rated power | KW | 700 |
| 2 | Rated current | A | 1064 |
| 3 | Heating area | ㎡ | 7000-10000 |
| 4 | input voltage | 50HZ | 380V |
| 5 | Minimum flow of water pump configuration | L/min | 850 |
| 6 | Hot water yield 50 ℃ | L/min | 327.6 |
| 7 | Design thermal efficiency | ℃ | 98% |
| 8 | Maximum water temperature | ℃ | 85 |
| 9 | Low temperature protection temperature | ℃ | 5 |
| 10 | Overall dimension (length * width * height) | mm | 3500L*1200W*2000H |
| 11 | Water inlet and outlet interface | DN | 100 |
Technical Description Of Electric Heater Boiler:
1. The circulating water pump shall match the power of the electric
heater boiler
The power of the electric heater boiler determines the hot water
supply speed. The circulation speed of the water pump must be as
close as possible to the hot water supply speed. If the circulation
speed of the water pump is too small, the end temperature of the
heat pipe network will not meet the heating standard. If the
circulation speed of the water pump is too fast, the electric
heater boiler will always operate at high power, resulting in a
waste of electric energy. This is because too fast water flow will
make the return water temperature closer to the outlet water
temperature. The electric heater boiler also has to do the action
of boiling water, resulting in a waste of electric energy. This is
not necessarily the case. The whole cycle of some buildings will be
very long. In this case, the whole cycle can be appropriately
accelerated.
2. Safety factors shall be considered for the installation position
of electric heater boiler
First, try to avoid children's contact. The functions of the
electric heater boiler are relatively diversified. Children's
misoperation may lead to changes in heating settings. Electric
shock can also be caused in the same way. The installation position
of the electromagnetic boiler shall be dry and ventilated to avoid
installation in the kitchen and toilet. Because there is a risk of
being flooded.
3. Irregularly check the water volume and pay attention to
supplement
Water leakage in the pipe network is very common. Slight water
leakage will not cause damage, but will reduce the heating effect.
The electric heater boiler has the function of monitoring water
volume, which is generally reflected in the panel warning or the
water level gauge. Observe the water level frequently and
supplement it in time to save power.
4. Install the exhaust valve
In the sealed pipe network, the heating water will produce a
certain amount of gas, and the gas will be filled in the case of
water leakage. In order to ensure the stability of the heating
effect, it is necessary to install an exhaust valve and exhaust
regularly.
